Replacing Piston (30) And Cap (31); Disassembling The Rake (2); Replacing The Teeth; Dismantling The Machine When No Longer Used - CAMPAGNOLA OLISTAR Manual De Uso Y Mantenimiento

6 - MAINTENANCE

6.2.4 Replacing piston (30) and cap (31)

•
Loosen the screws (18) that secure the cover on the air outlet deviator (19).
•
Remove the stainless steel plate (20), paying careful attention to the special seals.
•
Remove the distributor plugs (33) and then the piston (30).
•
Check the wear-and-tear of seals (29) and pad (31) and replace them even if only slightly worn out.
•
Perform the steps in reverse order to reassemble the parts.

6.2.5 Disassembling the rake (2)

Perform the steps in the order given below:
•
Take off the guard (11) for the links.
•
Locking the tool in a clamp, pry with a screw driver to remove the spring (7) and link (6), loosen the self-locking nut (3) and
remove the pin (5).
•
Put the guard (11) back on.
•
Perform the steps in reverse order to reassemble the parts.
6.2.6 Teeth replacement in the Diablo, Diablo 1800 Evo and Piuma models
The damaged teeth have to be removed from their seat:
Separate the small protrusions (4), locking the tooth in its seat, by means of a screwdriver (see picture E)
Remove the damaged tooth following the arrow direction
Put the new tooth into its seat till the small locking protrusions (4) come out (picture D)
WARNING!
Never operate the tool when the guard (11) that protects the links is not in place.
7

- DISMANTLING THE MACHINE WHEN NO LONGER USED

7.1 Disposal of exhaust materials

After having been installed and during use, the machine does not cause any environmental pollution. However, through-
out its working life, some types of residual waste or exhaust materials (such as filters, oil, etc.) are being produced in
certain maintenance situations.
There are specific regulations in every Country as for the disposal of these materials and the environment protection.
The Customer is required to be knowledgeable in the Laws in force in his own Country and to operate only while
complying with these regulations, according to the indications in the product technical charts, which may be obtained
from the Manufacturer.
WARNING!
The Laws in force about the disposal of mineral oils must be followed.
WARNING!
More information about the disposal of oils and other substances can be found in the safety chart of the substances
and/or in the engine manual.
The steps employed in the disposal of toxic waste including the collecting, transporting, processing (transformation
for recycling), as well as the deposit and the dumping onto the ground are all usual activities of common interest and
are subjected to the following general principles:
a) Any risks of injuries or dangers for the health and safety of any individual and of the community have to be
avoided;
b) Compliance with any and all hygienic-sanitary requirement and avoidance of any air, water, ground and
underground pollution have to be guaranteed.
Compliance with efficient and economical principles in order to save and recycle energy and materials shall be promoted.
26 - 92