Publicidad
Idiomas disponibles
Idiomas disponibles
BIT STORAGE
AREA
base where it is always handy and unlikely to
Your tool is equipped
with a bit and storage
get lost or misplaced
(Fig. 1).
area that is conveniently
located
in the handle
INSERTING AND RELEASING BATTERY PACK
Set Forward/Reversing
lever to the center (off
position).
Slide charged
battery pack into the
housing
until
the battery
pack
locks
into
position (Fig. 8).
Your tool is equipped with a secondary
locking
latch
to prevent
the
battery
pack
from
completely
falling out of the handle,
should
it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
Press the battery
pack release
button
again
and slide the battery
pack completely
out of
tool housing (Fig. 8).
IMPORTANT CHARGING NOTES
1. The charger
was designed
to fast charge
the battery only when the battery temperature
is between 32°F (0°C) and 113°F (45°C). If the
battery pack is too hot or too cold, the charger
will not fast charge
the battery.
(This
may
happen
if the battery
pack is hot from hea W
use). When the battery temperature
returns to
between
32°F (0°C) and 113°F
(45°C),
the
charger will automatically
begin charging.
2. A substantial
drop
in operating
time per
charge
may mean
that the battery
pack
is
nearing
the end of its life and should
be
replaced.
3. Remember
to unplug charger during storage
period.
4. If battery does not charge properly:
a. Check for voltage at outlet by plugging
in
some other electrical device.
b. Check to see if outlet is connected
to a
light switch which turns power "off" when lights
are turned off.
c. Check
battery
pack terminals
for dirt.
Clean
with
cotton
swab
and
alcohol
if
necessary.
d. If you still do not get proper
charging,
take or send tool, battery pack
and charger to
your local Bosch Service
Center.
See "Tools,
Electric"
in the Yellow
Pages for names
and
addresses.
Note:
Use of chargers or battery packs not
sold by Bosch will void the warranty.
CHARGER INDICATORS, SYMBOLS AND MEANING (Model B0630)
If the indicator
lights are "OFF", the charger is
not receiving power from power supply outlet.
I
*" I .., If the green indicator light is "ON",
_..@,, the charger is plugged in but the
battery
pack is not inserted,
or
the battery pack is fully charged.
..', o ]If the
green
indicator
light
is
[ _)
-:',@_--J"BLINKING", the battery
pack is
° ' "
being fast-charged.
Fast-charging
will automatically
stop when the battery pack is
fully charged.
.,,_,,
N_-
If the red indicator
light is "ON",
.. ! .. _=
the battery pack is too hot or cold
for fast-charging.
The charger will
automaticall'
switch
to fast-charging
once a
suitable tem )erature is reached.
I-_
_
If the
red
indicator
light
is
-
-'-
"BLINKING",
the battery
pack
" " "
cannot
accept
a charge
or the
contacts
of the charger
or battery
pack are
contaminated.
Clean
the contacts
of the
charger
or battery
pack only as directed
in
these operating
instructions
or those supplied
with your tool or battery pack.
-11-
Publicidad
