Briggs & Stratton Generac 2700 PSI Manual Del Usuario página 6

• Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensurescrews are tight but not
crushing the plastic accessory tray.
• Placethe handle assembly onto the handle supports
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure 2).
Atig
Handle
Supports
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the "L" bolt through the hole on the left side of
the handle (viewing from handle side of unit) and attach
the plastic knob. Tighten the knob by hand (Figure 3).
: .
y-.
• Insert the carriage bolt through the right side hole from
the outside of the unit and attach a plastic knob from the
inside of the unit (viewing unit from the handle side).
Tighten by hand (Figure 3).
• Insert the "J"hook into the second from the left slot in
the accessory tray (Figure 4).
• Pinch the chemical hose and slide it into the metal clip as
shown in Figure 5.
• Tilt the unit up by the handle and attach the metal clip to
the rib on the center undersideof the accessory tray
(Figure 6). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
Add Gasoline
_IL WARNING! Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
/
6