Descargar Imprimir esta página

Briggs & Stratton Generac 2700 PSI Manual Del Usuario página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: For a warm engine, be sure the choke lever is in
the "Run" position.
• Grasp the unit's handle with your left hand. Pull the
starter grip lightlywith your right hand until you feel
some resistance, then pull briskly.
• Return the starter grip handle slowly. Do Not let rope
"snap back" against starter.
• When engine starts, slowly move choke lever to the
"Run" position. If engine falters, move choke lever to
the "Choke" position, then to the "Run" position.
• If engine fails to start after six pulls, move choke lever to
the "Run" position. If engine fires, but does not continue
to run, move choke lever to the "Choke"
position, then
to the "Run" position.
NOTE: If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.
How
to Stop
Your
Pressure
Washer
• Move throttle lever to "Stop" position.
• Turn the fuel shut-offvalve to the "Off' position (fully
clockwise).
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension and quick connect nozzles, and
slots to hold the cleaning solution bottle and the detergent
siphoning filter. There are also two hooks at the ends of
the handle to hold your spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
includedwith your pressure washer. You can buy these
items as optional accessories.
• Placethe nozzle extension through the hole on the
accessory tray, as shown in Figure16.
• Hang your chemicalsolution bottle on the "J" hook and
place the detergent siphoning filter in the lastslot on the
left (Figure 16).
• Placethe spray gun on the hook attached to the
accessory tray on the right side of the unit (Figure 16).
• Hang the high pressure hose on the hook attached to
the accessory tray on the left side of the unit as shown
on page 4.
/
9

Publicidad

loading