Epson OT-BX88 Manual De Instalación página 8

English
English
7. Remove the two fixing tapes.
8. Connect the DC cable connector and all the cables to the printer.
9. Put on the connector cover (8 in illustration H), and then push it until it
clicks into place. (See illustration H.)
Note:
• Be sure to pass the cables out through the exits of the connector cover.
• To remove the connector cover, turn the printer over, and push the connector
cover down while pushing both sides of the connector cover inward. (See
illustration I.)
10. Connect the power cable.
Note:
The PS-Cover has a projection (9 in illustration J) to prevent the power cable
connector from coming loose from the printer. Wrap the power cable around the
projection as shown in illustration J.
4 OT-BX88 Installation Manual