Kenmore 110.81422 Manual De Uso Y Cuidado E Instrucciones De Instalación página 33

If you experience
TROUBLESHOOTING m WASHER (cont.)
First try the solutions suggested here for assistance and to possibly avoid a service call.
Possible causes Solution
Water level seems The top of the agitator is much higher This is normal and necessary for clothes to move freely.
too low, or the washer than the highest water level.
appears to not fill
completely
Clothes not completely This washer uses much Jesswater than Clothes may not be completely covered with water.
covered with water traditional top-load washers.
Dry spots on load This washer uses much Jesswater than Wash a smaller load.
after cycle traditional top-load washers.
High speed spins extract more
moisture than traditional top=load
washers.
Check for proper water supply. Incorrect or wrong
wash or rinse
temperatures
The high spin speeds combined with air flow during the final
spin can cause items near the top of the load to develop dry spots
during the final spin. This is normal.
Check that hot and cold inlet hoses are not reversed.
Both hoses must be attached to both washer and faucet, and
have both hot and cold water flowing to inlet valve.
Check that inlet valve screens are not clogged.
Remove any kinks in hoses.
Energy-saving controlled This washer uses cooler wash and rinse water temperatures
wash temperatures, than your previous washer. This includes cooler hot and warm
washes.
Load not rinsed Check for proper water supply.
Sand, pet hair, lint,
etc. on load after
washing
Load is tangling
Not cleaning or
removing stains
Using too much detergent.
Washer not loaded as recommended.
Heavy sand, pet hair, lint, and
detergent or bleach residues may
require additional rinsing.
Washer not loaded as recommended.
Washer not loaded as recommended.
Adding detergent on top of load.
Check that hot and cold inlet hoses are not reversed.
Both hoses must be attached and have water flowing to the
inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.
The suds from too much detergent can keep washer from
operating correctly. Always measure detergent and follow
detergent directions based on load size and soil level.
The washer is Jess efficient at rinsing when load is tightly packed.
Load garments in loose heaps evenly around the basket wall.
The washer will not rinse well if tightly packed. Load with dry
items only.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 garments after washer has started.
Increase soil level setting.
See "Washer Use" section.
Select a cycle with a slower wash action and spin speed;
however, items wJJJbe wetter than those using a higher
speed spin.
Load garments in loose heaps evenly around the basket wall.
Reduce tangling by mixing types of load items. Use the
recommended cycle for the type of garments being washed.
Washer is Jess efficient at cleaning when load is tightly packed.
Load garments Jn loose heaps evenly around the basket wall.
Load with dry items only.
Add only 1 or 2 garments after washer has started.
Add detergent, oxi products, and color-safe bleach to the
bottom of the basket before adding the load items.
J
33