Mounting Of Handle; Mounting Of Protector; Mounting Of Nylon Cutting Head - Dolmar LT-210 Manual De Instrucciones Original

MOUNTING OF HANDLE

CAUTION: Before doing any work on the string trimmer, always switch off
the engine and pull the spark plug connector off the spark plug.
Always wear protective gloves.
CAUTION: Start the string trimmer only after having assembled it completely.
For machine with Loop handle
– Attach the handle to the shaft.
– After the loop handle (1) is in place, tighten the three screws (2).
Be sure the bolts are tight, but do not over tighten.
– Adjust the handle to the desired position over 200mm away from the rear
grip (3) and tighten the three screws (2).

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector combinations
as indicated in the table must be used.
Be sure to use genuine DOLMAR nylon cutting head.
– If the nylon cutting head hits against a stone during operation, stop the
engine and check the nylon cutting head immediately.
– Attach the protector (6) to the shaft.
– Insert the nut M6 (5) into the hex hole in the protector (6).
– Secure the protector with the installation bolt M6 x 45 (4).
NOTE:
Do not tighten the installation bolt M6 x 45 (4) excessivley.
MOUNTING OF NYLON CUTTER HEAD
Turn the machine upside down, and you can replace the nylon cutting head.
– Insert the hex wrench provided through the hole in the head case and rotate
the support washer until it is locked with the hex wrench (or the shaft is
locked).
– Screw the nylon cutting head onto the shaft.
Nylon cutting head
8
Protector for nylon
cutting hesd