Worx WG430 Manual De Instrucciones página 7

Keep c ord from heat, oil, a nd sharp e dges.
12)Don't grasp theexposed cutting b lades or
cutting e dges when picking uporholding
theappliance. (For g rass shears and
similar appliances only.)
13)Don't Force Appliance -Itwill d othe job
better and withless likelihood ofarisk of
injury a ttherate forwhich i twas designed.
14)Don't Overreach -Keep proper footing a nd
balance atall t imes.
15)Stay Alert -Watch what y ou are doing.
Use common sense. Donot o perate
appliance when y ouare tired.
16)Disconnect Appliance -Disconnect the
appliance from thepower supply when n ot
inuse, before servicing, when c hanging
accessories such a sblades, and the like.
17)Store Idle Appliances Indoors -When n otin
use, appliances should b estored i ndoors
indry, a nd high orlocked-up place- outof
reach ofchildren.
18)Maintain Appliance With Care - Keep
cutting e dge s harp a nd clean f orbest
performance and toreduce therisk of
injury. Follow i nstructions forlubricating
and changing accessories, inspect
appliance cord periodically, and if
damaged, have i trepaired byanauthorized
service facility, inspect extension cords
periodically and replace ifdamaged. Keep
handles dry, c lean, and free from oiland
grease.
19)Check Damaged Parts -Before further use
ofthe appliance, aguard o rother part that
isdamaged should b ecarefully checked
todetermine that i twilloperate properly
and perform i tsintended function. Check
foralignment ofmoving parts, binding of
moving parts, breakage ofparts, mounting,
and any other condition that m ay affect
itsoperation. Aguard o rother part that i s
damaged should b eproperly repaired or
replaced byanauthorized service center
unless indicated elsewhere inthis manual.
Tab|e 57.1 Minimum gauge for extension
cords
Volts
120V
240V
Ampere Rating
More than Not more
than
0-6
6-10
10-12
12-16
Total length of cord in feet
150
300
AWG
18 16 16 12
18 16 14 12
16 16 14 12
Not
recommended
NOTE-Only the applicable parts of theTable need to be
included. For instance, a 12g-volt product need not include
the24O-volt heading.
Figure 57.2
Method of securi.g exte.sio, cord
CORD APPLIANCE CORD
SET [_
, ......... i, i
//
(A) Tie cord as sho_
(B) Connect p|ug a.d receptac|e
ADPITIONAL SAFE
RULES '8R L :AF MULCHER
WARN|NG". The leaf mulcher is
designed to shred leaves, grass
clippings, pine needles etc, it can not be used
to shred branches, sticks or brush.
1. Become familiarwith all sections of this
owner's manual before attempting to
operate the leaf mulcher.This leaf mulcher
should be used solely for the purpose it
was intended.
2. Use only parts or accessories specifically