Worx WG430 Manual De Instrucciones página 8

designed foruse withthis leaf m ulcher.
Using o ther parts o raccessories could
increase risk of injury.
3. Keep Children Away - all visitors should be
kept at a distance from the work area.
4. Never allow your hands or any part of your
body or clothing inside the upper housing
area or funnel.
5. Avoid Dangerous Environments - do not
use leaf mulcher in damp or wet locations.
Do not operate in rain. Store indoors when
not in use, in a dry, and high or locked up
place - out of reach of children.
6. This leaf mulcher should be operated on a
solid, level surface.
7. Dress properly- do notwear loose clothing
or jewelry.They can be caught in moving
parts. Use of work gloves and substantial
footwear is advised when working
outdoors. Wear protective hair covering to
contain long hair.
8. Stay Alert -Watch what you are doing.
Use common sense. Do not operate leaf
mulcher when you are tired.
9. Do not abuse power or extension cords -
Never carry unit by its power cord or yank
cord to disconnect from receptacle. Keep
all cords clean and away from heat, oil and
sharp edges and inspect for damage before
each use.
10.Warning -To reduce the risk of electrical
shock, use only an extension cord intended
for outdoor use.
11. Ground fault circuit interrupter (GFCI)
protection should be provided on the
circuit(s) or outlet(s)to be used for this leaf
mulcher. Receptacles are available having
built-in GFCI protection and may be used
for this measure of safety.
12.if it is necessary for any reason to inspect,
clean or repair the leaf mulcher, turn the
leaf mulcher off and wart until it comes to a
complete stop, then disconnect the power
cord before attempting such inspection or
repair.
13.Disconnect leaf mulcher from the power
source when not in use, before servicing,
and when changing cutting lines.
14.When feeding material into the leaf
mulcher be extremely careful that pieces of
metal, rocks, bottles, cans or other foreign
objects are not included.
15.Do not force the leaf mulcher. It will do the
job better and with less likelihood of a risk
of injury when used at the rate for which it
was designed.
16.If the cutting mechanism strikes a foreign
object or if your leaf mulcher should start
making an unusual noise or vibration,
immediately switch it off, wait until the leaf
mulcher has come to a complete stop.,
then disconnect the power cord and take
the following steps:
a) Remove any foreign or clogged material.
b) Check for any loose parts and tighten to
assure continued safe operation.
c) Replace or repair any damaged parts.
17. Avoid unintentional starting. Be sure switch
is off when plugging in the leaf mulcher.
18.Always use safety glasses. Wear face or
dust mask if operation is dusty.
19.Check discharge area periodically after
stopping leaf mulcher to assure the
processed material does not build up and
clog motor cooling vents.
20.Do not overreach - keep proper footing and
balance at all times.
21.Do not move leaf mulcher when motor is
running or with finger on the switch.
22.Maintain leaf mulcher with care - Follow
instructions for replacing cutting lines and
for cleaning air filter. Inspect leaf mulcher
power cord periodically, and if damaged,
have it repaired by an authorized service
facility. Keep handles dry, clean, and free
from oil and grease.
23.Check Damaged Parts - Before further
use ofthe leaf mulcher, any part that is
damaged should be carefully checked to
determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other condition that may affect
its operation, a guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
SAVE THESIS INSTRUCTIONS