Black and Decker MS800 Manual De Instrucciones página 8

• Push theother end ofthecontour sanding piece u ntil itclicks i ntoplace.
• To remove the contour sanding piece, push it forward then pull the rear end out of
the contour holder (fiq. 7).
Fitting a Sanding Sheet Onto a Contour Sanding Piece (Fig. 8)
• Align the sanding sheet with the contour sanding piece.
• Press the sanding sheet onto the contour sanding piece, making
sure that the sanding sheet follows the shape of the profile.
Dust Extraction (Fig. 9)
To Empty Dust Canister:
• The dust canister should be emptied after every 10 minutes of sanding.
• While holding the sander, grasp the dust collection canister and pull off of the sander.
• Remove the canister door and gently shake or tap the canister and door to empty.
Re-attach the door and firmly push the canister back onto the sander.
CAUTION: Respiratory hazard. Never operate this tool for wood sanding unless
the dust canister is in place. Sanding dust exhaust may create a breathing hazard.
Z_WARNING: Fire hazard. Collected sanding dust from sanding surface coatings
(polyurethane, linseed oil, etc.) can self-ignite in sander dust canister or elsewhere and
cause fire. To reduce risk, empty canister frequently and strictly follow sander manual and
coating manufacturer's instructions.
Z_WARNING: Fire hazard. When working on metal surfaces, do not use the dust canister
or a vacuum cleaner because sparks are generated. Wear safety glasses and a dust
mask. Due to the danger of fire, do not use your sander to sand magnesium surfaces. Do
not use for wet sanding.
Problem Possible Cause Possible Solution
• Unit will not start. • Cord not plugged in. • Plug tool into a working outlet.
• Circuit fuse is blown. • Replace circuit fuse.
(If the product repeatedly causes
the circuit fuse to blow, discontinue
use immediately and have it
serviced at a Black & Decker service
center or authorized servicer.)
• Circuit breaker is tripped. • Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip, discontinue
use immediately and have it
serviced at a Black & Decker service
center or authorized servicer.)
• Cord or switch is damaged. • Have cord or switch replaced at
Black & Decker Service Center or
Authorized Servicer.
• Dust is not • Sandpaper holes do not align. • Use Mousd R_ s andpaper with the
being collected, appropriate hole configuration.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1=800=544=6986.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
A variety of Mousd R_ a ccessories are available at extra cost. Listings per retailer may vary.
Note: Use only sandpaper with holes in the same configuration as on the base of the