Hilti DX 6-GR Manual De Instrucciones Original página 32

Noise information in accordance with EN 15895
Sound power level (L
WA
Emission sound pressure level (L
Peak sound pressure emission level (L
Vibration information in accordance with EN 2006/42/EG
Vibration emission
5 Preparations at the workplace
5.1 Assembling the fastening tool
1. Make sure that there are no cartridge strips in the fastening tool.
2. Bring the arrow marks into alignment and insert the exhaust gas piston return unit into the housing.
3. Insert the fastener guide centered into the exhaust gas piston return unit.
4. Fit the piston.
5. Fit the buffer onto the fastener guide.
6. Insert the fastener guide centered and not tilted into the exhaust gas piston return unit.
7. Turn the fastener guide clockwise until it engages.
▶ The fastener guide is locked.
5.2 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product
as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure.
Check that the carabiner holds securely.
Comply with the operating instructions of the
Hilti tool tether.
5.3 Scaffold hook (accessory)
The Hilti scaffold hook (accessory) can be installed and used for hooking the product to a railing or a tool-
belt for a short time. To install the accessory, follow the installation instructions provided with the accessory.
There is a copy of the installation instructions at the end of these operating instructions.
The fastening tool must additionally be secured with the Hilti tool tether.
24 English
)
)
pA
)
pCpeak
3
106 ±2 dB
103 ±2 dB
134 ±2 dB
< 2.5 m/s²
2253453
*2253453*