GE PFW870 Manual Del Propietario E Instalación página 15

Using the washer
Dryer Control – Bluetooth
(on some models)
1. Power on both the washer and the dryer but do not start any
cycles.
2. Press and hold the Tumble Care button on the
washer for 5 seconds until the Bluetooth
starts to flash and you hear an audible tone.
3. Open and close the dryer door 3 times within 10 seconds to
make it discoverable to the washer.
4. The washer will attempt to discover the dryer, the Bluetooth
icon will flash and both displays will blink " - - - ".
5. The Bluetooth ® icon on the washer should illuminate solid
signifying that the machines are now paired. The display on
the washer will display "bt" once pairing is complete.
®
6. If the Bluetooth units fail to pair, repeat above steps 1-5.
7. To unpair the machines, press and hold the Tumble
Care button for 10 seconds or open and close the
dryer door 3 times within 10 seconds.
How to use the Dryer Control Feature (on some models)
1. Power on the washer.
2. Press and hold the Dryer Control button on the
washer for 3 seconds to power on the dryer.
3. The dryer's cycle selection will flash to display the
recommended sensor cycle that pairs to the last completed
washer cycle as the washer display reads "drY".
4. To use this cycle, press the Dryer Control button to
start the dryer. The dryer can be paused by opening
its door or pressing the Dryer Control button. To restart
the dryer with its door closed, press the Dryer Control
button again.
5. To select Timed Dry instead of the sensor dry cycle, press the
Timed Dry button on the washer while the display says "drY".
Repeated presses of this button will step through preset Timed
Dry times (default is 10 minutes).
6. Once you've selected the Timed Dry cycle's duration,
press the Dryer Control button within 10 seconds to
start the dryer.
49-3000368 Rev 0
®
Pairing
®
LED ( )
Open and close
dryer door
3 times within
10 seconds
®
Washer
Dryer
NOTE: Your dryer's control panel is fully
functional even when you are using Dryer
Control through the washer.
Powering off the washer will not power off
the dryer when a dry cycle is in progress.
Scan for
instruction
Scan for
instruction
15