Publicidad
Idiomas disponibles
Idiomas disponibles
F
5
Remove any debris and/or hair from the brushroll.
Then slip other end of belt around area of
brushroll without bristles (F). With belt in place,
pull and slide brushroll into nozzle making sure
that the brushroll end caps are in the correct
orientation.
A
B
6
Reposition bottom plate, aligning latch (B) and
fastening all (6) screws (A). Press firmly at latch
(B) area to ensure that it is properly latched.
LUBRICATION: The motor and brushroll are
equipped with bearings which contain sufficient
lubrication for their lifetime. The addition of
lubricant could cause damage. Do not add
lubricant to motor or brushroll.
TROUBLESHOOTING
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at 1-800-944-9200 prior to
continuing use.
If you need further assistance: To speak with a customer service representative call
1-800-944-9200; Mon-Fri 9am-7pm EST. Always identify your vacuum by the complete model number when requesting information or ordering parts. (The
model number appears on the back of the vacuum.)
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE.
WARNING:
To reduce the risk of personal injury - Unplug before cleaning or servicing.
PROBLEM
POSSIBLE CAUSE
Vacuum won't run
1. Power cord not firmly plugged into outlet.
2. Blown fuse or tripped breaker.
3. Thermal Protector activated.
System Check Indicator has turned
1. Rinsable Filter and/ or Filter made with HEPA media is dirty.
red or Vacuum won't pick up or Low
suction
2. Dirt cup full and/ or clogged.
3. Broken or worn belt.
4. Brushroll and/ or Hose clogged.
5. Carpet height setting is incorrect.
Dust escaping from vacuum
1. Dirt cup full.
2. Dirt cup not installed correctly.
3. Hose not installed correctly.
4. Rinsable and/ or Filter made with HEPA media not installed
Vacuum is difficult to push or won't
1. Carpet height setting is incorrect.
move forward
2. Belt is broken
Turbo Tool brushroll won't turn
1. Too much pressure being applied to tool.
2. Blockage
3. Low vacuum suction.
Smoky/burning smell detected
1. Belt broken or stretched.
2. Brushroll is clogged.
completely.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace fuse/reset breaker
in home.
3. Unplug and allow vacuum to cool for 30min.
(This will reset the thermal protector)
1. Clean Rinsable Filter and or Filter made with HEPA media.
- Pg. 3
2. Empty dirt cup. - Pg. 3
3. Replace belt. - Pg. 5
4. Check Hose. Check Brushroll. - Pg. 4– 5
5. Set Carpet Height Adjustment to appropriate setting for carpet
being cleaned. - Pg. 2
1. Empty dirt cup. - Pg. 3
2. Review Dirt Cup removal & replacement. - Pg. 3
3. Review Hose installation. - Pg. 4
4. Review Filter Removal and Cleaning. - Pg. 3
1. Set Carpet Height Adjustment knob to appropriate setting for
carpet being cleaned. - Pg. 2
2. Replace Belt
1. Continue using tool applying light pressure.
2. Remove blockage
3. Check items under "Vacuum won't pick up or Low suction."
1. Replace brushroll belt. - Pg. 4
2. Clear/ remove debris from brushroll. - Pg. 4
Publicidad
