cecotec BOLERO FLUX PM 606500 INOX A Manual De Instrucciones página 62

ENGLISH
- After installation, ensure that the kitchen hood is level to prevent grease build-up on the
end. Fig. 3
1. The kitchen hood should be placed at a distance of 65-75 cm above the cooking surface
for best effect.
2. Install the wall hook in a suitable location and set the installation height. Keep it aligned.
Use the screws to fix it to the wall. Fig. 4
3. Fix the outer bracket on the chimney, Fig 5, and make sure that the inner part of the chimney
can be adjusted to the installation height, as well as that of the flexible connection pipe.
Then, install the flexible connection pipe in the chimney of the kitchen hood. Fig. 6
4. Place the kitchen hood on the hook on the wall. Fig. 7
5. Adjust the height of the inner part of the chimney to the position of the inner bracket and
fix it with screws (ST4*8 mm). After adjusting the position of the kitchen hood, fix the body
with safety screws (ST4*30 mm). Fig. 8
Note: There are two safety ventilation ducts in the back housing.
4. OPERATION
Power buttons
1. To switch on the kitchen hood, press any of the power buttons.
2. If you press the low power button, the kitchen hood will beep, and the motor will operate
at low speed.
3. If you press the medium power button, the kitchen hood will beep, and the motor will
operate at medium speed.
4. If you press the high-power button, the kitchen hood will beep, and the motor will operate
at high speed.
5. If you press the light button, both bulbs will light up. Press it again and the light will switch
off.
6. Press the off button, the motor will switch off.
5. CLEANING AND MAINTENANCE
Cleaning aluminium filters
Do not use corrosive detergents to clean grease from the aluminium filters. Regular cleaning
of the aluminium filters will prolong the life of the appliance and keep it in good working order.
Figure 9 shows how to release the filter from the kitchen hood.
Follow the instructions below:
62
BOLERO FLUX PM 606500 INOX A / BOLERO FLUX PM 606500 BLACK A