cecotec BOLERO FLUX PM 606500 INOX A Manual De Instrucciones página 11

- The minimum distance between the support surface of the
cookware on the cooker and the lowest part of the kitchen
hood must be 65-75 cm. (When the kitchen hood is located
above a gas appliance, this distance shall be at least 65 cm).
- The minimum distance between the support surface of the
cooking containers on the worktop and the lowest part of
the kitchen hood, when it is located above a gas appliance,
must be at least 65 cm. If the installation instructions for the
gas appliance specify a greater distance, this must be taken
into account. The distance of 65 cm can be reduced for:
o Non-combustible parts of kitchen hoods
o Parts operating at safety extra-low voltage (provided
that these parts do not give access to live parts if they are
deformed)
- The kitchen hood is not designed to be installed over a hob
with more than 4 cooking zones.
- When the kitchen hood and other non-electrically powered
appliances are in simultaneous operation, the negative
pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
- Air must not be discharged into a duct that is used to exhaust
fumes from appliances burning gas or other fuels.
- Kitchen hoods and other kitchen extractor fans may
adversely affect the safe operation of appliances burning
gas or other fuels (including those in other rooms) due to
the backflow of combustion gases. These gases can cause
carbon monoxide poisoning. After installation of a kitchen
hood or other kitchen extractor fan, the operation of open
gas appliances must be checked by a competent person to
ensure that there is no backflow of combustion gases.
- The air discharge regulations must be complied with.
- The kitchen hood is intended for installation only over a hob
with four cooking zones.
BOLERO FLUX PM 606500 INOX A / BOLERO FLUX PM 606500 BLACK A
11