cecotec BOLERO COOLMARKET TT ORIGIN 45 Manual De Instrucciones página 23

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Storage compartment
2. Temperature knob
3. Tray
4. Shelf
5. Door shelf
Note
:
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
3. INSTALLATION
Installation
1. Place the refrigerator on a completely flat surface. Leave 5~10 cm between each side of
the appliance and the wall, and 30 cm between the top of the appliance and the ceiling.
2. Choose a place that is not exposed to sunlight, high temperatures, or humidity, as
moisture can cause stains.
3. Remove the bottom panel before installation.
4. The appliance can be adjusted via its two front support feet. You can raise the appliance
by turning them clockwise.
5. Choose a solid and flat surface for installation. Improper levelling and installation can
cause noise and vibrations:
a. Noise may increase if the floor is not solid.
b. You can place a sheet under the appliance to solve the heat-emission problem if you need
to place it on a carpet.
44 BOLERO COOLMARKET TT ORIGIN 45 RED/ BEIGE/ BLACK/ BLUE/ GREEN
6. Make sure the adjustable feet are securely on the floor, and adjust the tilt of the appliance
slightly backwards to keep the doors securely closed.
Installing the handle
Fig. 2 key:
1. Handle
2. Handle trim
3. Screws
4. Socket spanner
1. Remove the accessories from the packing bags: the handle, the handle trim, and the three
screws.
2. Take a socket spanner.
3. Make sure the three screw holes of the handle screws are aligned with those of the door,
then screw them in respectively.
4. Install the handle trim on the handle.
4. OPERATION
- The temperature of the refrigerator can be manually controlled via the knob. However, the
number displayed on the knob isn't directly indicative of interior temperature.
- The higher the number, the lower the interior temperature.
- 0 means off.
- Turn the knob to 4 for normal use, turn it between 4-7 if you need a lower interior
temperature, and between 4-1, if you need a higher interior temperature.
5. INSTRUCTIONS ON FOOD STORAGE
Use precautions
- The appliance may not operate consistently (there may be some defrosting of the contents
or the temperature may become too hot) if placed in locations with a temperature outside
of the temperature range for which the refrigerator is designed for a long period of time.
- Information on the climatic class of the appliance can be found in the Technical
Specifications section and on the appliance marking.
- The internal temperature may be affected by factors such as the location of the appliance,
room temperature, door opening frequency, etc., and you should take these factors into
account if you decide to use any temperature-control devices.
- It is not recommended to store liquids in glass containers or soft drink cans in the storage
BOLERO COOLMARKET TT ORIGIN 45 RED/ BEIGE/ BLACK/ BLUE/ GREEN
ENGLISH
45