Start-Up And Use; Using The Hob; Using The Oven - Indesit I6MG1G/EX Manual De Instrucciones

Start-up and use

Using the hob

GB
Lighting the burners
For each BURNER knob there is a complete ring
showing the strength of the flame for the relevant
burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting .
3. Adjust the intensity of the flame to the desired level
by turning the BURNER knob in an anticlockwise
direction. This may be the minimum setting , the
maximum setting  or any position in between the two.
X
flame setting, until the burner is lit.The burner may be
extinguished when the knob is released. If this occurs,
repeat the operation, holding the knob down for a longer
period of time.
! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight it.
If the appliance is equipped with a flame failure safety
device*(X), press and hold the BURNER knob for
approximately 2-3 seconds to keep the flame alight
and to activate the device.
To switch the burner off, turn the knob until it reaches
•.
the stop position
Practical advice on using the burners
For the burners to work in the most efficient way
possible and to save on the amount of gas consumed, it
is recommended that only pans that have a lid and a flat
base are used. They should also be suited to the size of
the burner.
To identify the type of burner, please refer to the
diagrams contained in the "Burner and nozzle
specifications".
10
If the appliance is fitted
with an electronic lighting
device* (D ), press the
ignition button, marked

with the symbol
hold the BURNER knob
down and turn it in an
D
anticlockwise direction,
towards the maximum
! On the models supplied with a reducer shelf,
remember that this should be used only for the
auxiliary burner when you use casserole dishes with a
diameter under 12 cm.0
Flame adjustment according to levels
the burner flame intensity can be adjusted with the
knob according to 6 power levels, from maximum
to minimum with 4 intermediate positions:
a click will indicate the change from one level to
another when turning the knob. The system
guarantees a more precise adjustment, allows
, then
to replicate the flame intensity and to identify
easily the preferred level for different cooking
operations
Electric hotplates*
The corresponding knob may be turned clockwise or
anti-clockwise and set to six different positions:
When the selector knob is in any position other than the
off position, the 'on' light comes on.

Using the oven

! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
WARNING! The glass lid can break
in if it is heated up. Turn off all the
burners and the electric plates
before closing the lid.