Publicidad
3ONT PANEL
DENON eco
suo cowronent avsu steno fusca tum
22GB BG =~ BBE smmnzasine
STEREO MEMORY SCAN AUTO TURING DILOCAL
«= MANUAL TUNING
POWER (Power On/Off Switch)
The unit works 2-3 seconds after this switch is turned' on.
IF BAND (IF Band Selector Button)
Selects the selectivity of the FM intermediate frequency
amplification band from 3 ranges, "WIDE",
"NARROW"
and "SUPER NARROW",
This switch is not effective during
"Preset Scan"
and
"AUTO MEMORY".
IF MODE (iF Mode Button)
Selects "AUTO" or "MANUAL"
IF Band selection.
AUTO:
The optimum
IF band
is set automatically for
each FM station being received.
MANUAL:
The IF band remains fixed.
MUTE (Mute Button)
Switches between 3 muting levels, "OFF", "LOW"
and
"HIGH".
MPX NR (MPX NR Button)
Switches MPX NR "OFF" or "AUTO."
AUTO:
'Suppresses noise when a stereo broadcast with
a weak signal is being received.
OFF:
Does not carry out the above operation.
REC CAL (Rec Calibration Button)
Used
to set the recording
level of tape deck for FM
broadcast recording. The output is adjusted to approx-
imately half the peak level of the FM broadcast. Refer to
the user's manual for your tape deck or other recording
device.
MODE (Mode Button)
Switches "STEREO AUTO" or "MONO".
STEREO
AUTO
and MONO
are set automatically by the
internal microcomputer.
Monaural is set when a station
with a weak signal is being received, at which time this
button does not operate.
P. SCAN (Preset Scan Button)
a station has been received for about 5 seconds, the next
station in memory is scanned. Stations in memory which
Stop cannot be received.
MEMORY (Memory Button)
Used to store the frequency of the station currently re-
ceived.
Pressing [MEMORY], [7],
[ 2 ] , CENTER]
in order stores
ones
ew
et
woed
— autod
sequt.
HAREOW.
Low
SER NARROW)
MARIALS
OFF
10)
@
Fig. 4
AUTO (Auto Button)
Memory numbers 1-30 can be used.
from memory positions 3 to 20.
/=/
:
Auto Memory as described in item @.
BAND (Band Button)
Selects between FM or AM.
TUNING MODE (Tuning Mode Button)
quency.
as shown below.
paratively weak signal.
Auto stop is executed for strong sta-
tions.
TUNING (Tuning Buttons)
Used to change the received frequency to a higher fre-
quency (UP) or a lower frequency (DOWN).
High
ENTER (Enter Button)
Used for setting' Memory, Auto Memory and Preset Call.
TEN KEYS (Ten Key Buttons)
Used to specify numbers for Memory, Auto
Memory
and
Publicidad
