dixell WSH Serie Manual De Uso Y Mantenimiento página 39

3.4 Signaling concerning Safety
Signaling labels are present on the machine, which are indicated in Chart 3.
A
B
C
D
E
F
G
3.5 Work Area and Position of the Operator
The machine functions automatically, requiring the intervention of the operator in proximity of the control and command unit only
to manually start-up and stop the machine, and to program its functioning. The work area of the operator is, therefore, exclusively
Chart 3 – Description of the signaling labels present on the machine.
LABEL
This label indicates that it is forbidden to remove the safety devices and
protections installed on the machine; it is usually accompanied by the
explicatory writing:
This label indicates that it is forbidden to perform any intervention (including
lubrication and cleaning) in proximity of moving parts; it is usually
accompanied by the explicatory writing:
MOTION
This label warns about the danger due to the presence of mobile parts in
proximity of the area in which the machine is positioned.
This label warns about the danger due to the presence of warm surfaces in
proximity of the area in which the machine is positioned.
This label warns about the danger due to the presence of elements under
voltage in proximity of the area in which the machine is positioned.
This label warks about the obligation to read the manual for the
installation
Warning to the sharp part during condenser cleaning
DESCRIPTION
DO NOT REMOVE THE PROTECTION DEVICES
.
.
DON NOT REPAIR OR REGULATE DURING
WSH-WTH Pag. 39 REV. 01 04/14
UK