Publicidad
Idiomas disponibles
Idiomas disponibles
Do not lean over barbecue while lighting.
1.Turn gas burner control valves to OFF.
2.Open lid during lighting or re-lighting.
3.Turn ON gas at LP cylinder.
4.Turn Sear Burner knob to the HIGH position, push and hold ELECTRONIC IGNITOR button.
5.If Sear Burner does NOT light within 5 seconds, turn knob to OFF, wait 5 minutes, then repeat lighting
procedure.
Sear Burner Match Lighting
Do not lean over barbecue while lighting.
1.Turn gas burner control valves to OFF.
2.Open lid during lighting or re-lighting.
3.Turn ON gas at LP cylinder.
4.Place lit match near burner. Immediately turn Sear Burner knob to the HIGH position. Be sure the
burner lights and stays lit.
4
.. 87,21
63,'(5 $/(57
SPIDER AND WEBS
INSIDE BURNER
If your barbeque is getting hard to light or the flame is weak, check and clean the venturis and burners.
Spiders or small insects are known to create "flashback" problems by building nests and laying eggs in the
barbeque's venturi or burner obstructing the flow of gas. The backed-up gas can ignite behind the control panel.
This flashback can damage your barbeque and cause injury. To prevent flashbacks and ensure good
Publicidad
