cecotec BOLERO SQUAD V 2001 Manual De Instrucciones página 52

ENGLISH
6.6. Within 30 seconds of automatic heating mode operation, press the
a certain level, then the operating time is counted in the set level time.
For example, when the indicators "A" and "9" are displayed alternately and have been running
for 20 seconds. If you press the
be automatically counted in the 2.5 minutes of level 6; while level 6 will continue to run for 2.5
minutes minus 20 seconds, i.e. 2 minutes and 10 seconds. Afterwards, return to normal heating
mode.
7. Setting the timer
After selecting the corresponding power of the cooking zone, press the timer icon, the timer
display will show "00" and the right decimal point will appear.
It then enters the timer mode, and the timer time for the selected cooking zone can be set. In
timer mode, the following operations are required:
- If you want to cancel the timer, you can set the timer time to zero.
- The first time the
increase or decrease icon can be pressed to adjust the timer time.
- Each time the
1 minute. The time will continuously change between 1 and 99 minutes. The maximum
setting is 99 minutes.
- Each time the
1 minute. When the timer time is less than or equal to 30 minutes, the continuous setting
timer will continuously change between 30 and 0 minutes. If the timer has been set using
the icon for more than 30 minutes, press the
continue to change the timer continuously between 30 and 0 using the decrease icon.
- After the timer countdown reaches 0, the hob will continue beeping for 2 minutes. You can
press any icon to stop the beeping.
Please note
- If the time of a cooking zone has already been set, to change it press the timer icon again
to select the corresponding cooking zone and next, set the new time by pressing the
icons.
- Once the cooking zone has been selected, the time adjustment cannot be made before
adjusting the power of the cooking zone. Also, the timer icon will be disabled.
- When the timer for a certain cooking zone is set for the first time, pressing the cooking-
zone selection icon corresponding to the cooking zone when the timer is not confirmed
cancels the cooking zone timer.
- When one or both cooking zones are operating, the decimal point of the corresponding
cooking zone is always displayed during the time setting process.
- When several cooking zones are in operation and you have set the time, the timer display
shows the minimum time of the cooking zone. The decimal point of the corresponding
cooking zone is always lit. The decimal point of the display goes out until the end of the
countdown time.
52
BOLERO SQUAD V 2001
icon to set level 6, the 20 seconds that have elapsed will
icon is pressed, the timer starts from 1 minute, after which the
icon is pressed, the hob will beep, and the heating time will increase by
icon is pressed, the hob will beep, and the heating time will decrease by
icon to adjust to
icon to set the timer to 0, and
/