Publicidad
Idiomas disponibles
Idiomas disponibles
Select the duration for the timer-activated
period
TIMER PLAY
POWER
The unit can be turned on at a specified
time every day with the
built-in
timer.
Make sure the clock is set correctly.
(See page 7.)
Use the remote control.
7 Press the TIMER button repeatedly while pressing
the SHIFT button on the remote control to display
a.
2 Within 4 seconds, press the 11button.
The hour flashes.
m
3
4
If you do not press the II
button
within
4 seconds,
another
operation
may start.
Designate
the
hour
of
the
timer-on
time
by
pressing
the
++
or
>
button,
and
press
the
1 I button.
Repeat
to designate
the
minute
of the
timer-on
time.
Press
the
+<
or
EP
button
to select
a source
for timer play, then press the
11
button.
To listen to a radio broadcast,
select "FM" or "AM. "
You can change
the band later at step 6.
To listen to the equipment
connected
to theTAPE
IN jacks,
select "TAPE."
To listen
to the equipment
connected
to the AUX IN jacks,
select "AUX."
5
6
7
with the 4<
or E-P button, and press
button.
The duration for the timer-activated
period can be set between
5 and 240 minutes
in 5-minute
steps.
Prepare the source.
To listen to a CD, load the disc,
To listen to a radio broadcast,
select the desired
band and
tune in to a station.
To listen
to the connected
equipment,
set the timer of the
connected
source
(with an external
timer) and prepare
it for
play,
Press the POWER button to turn the svstem off
after adjusting the volume and tone.
@
remains
on the display
after the power is turned
off (timer
standby
mode).
When the timer-on
time is reached,
the system turns on and
begins
play with the selected
source.
If the volume
level was set to more than 25 when the power
was turned off, it is automatically
set to 25 when the unit turns
on by the timer.
To check the specified time and source
Press the TIMER
button while pressing
the SHIFT button on the
remote
control.
The selected
source
name, the timer-on
time
and the duration
for the timer-activated
period are displayed
for
4 seconds,
To cancel timer standby mode temporarily
Press the TIMER
button
repeatedly
while
pressing
the SHIFT
button
on the remote
control
so that "NO TIMER"
is displayed
on the display.
To restore the timer standby
mode, press again to display
~,
Using the unit while the timer is set
You can use the unit normally
after setting the timer.
Before turning off the power, repeat step 6 to prepare the source,
and adjust the volume
and tone.
m
Timer play will not begin unless the power is turned
off.
Connected
equipment
cannot be turned on and off by the built-
in timer of this unit.
Use an external
timer.
ENGLISH
13
Publicidad
