Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE SLEEP TIMER
SLEEP
I
U,bb
The unit can be turned
off automatically
at a specified
time.
Use the remote
control.
7 Press
the
SLEEP
button
while
pressing
the SHIFT
button on the remote control.
2 Within
4
seconds,
press the -
or
> button
to
specify the time-until the power is turned off.
Each time the button is pressed,
the time changes
between
5
and 240 minutes
in 5-minute
steps.
Specified
time
To check
the time
remaining
until the power
is turned
off
Press the SLEEP
button once while pressing
the SHIFT
button
on the remote
control.
The remaining
time
is displayed
for 4
seconds.
To cancel
the sleep
timer
Press the SLEEP
button twice while pressing
the SHIFT button
on the remote control
so that "NO SLEEP"
in displayed.
CONNECTING
OPTIONAL
EQUIPMENT
f'"
'1
~CD
DIGITAL
(OPTICAL)
TAPE IN
AUX IN
LINE OUT
\~
~
@@@
II
v
SUPER
WOOFER
OUT
Refer to the operating
instructions
of the connected
equipment
for details.
The connecting
cords are not supplied.
Obtain the necessary
connecting
cords.
Consult
your local Aiwa dealer for optional
equipment.
TAPE IN JACKS
This system
can input analog
sound
signals
from a tape deck
through
these jacks.
Use a cable with RCA phono plugs to connect
a tape deck.
m
When using tape deck to record the sound of this system, connect
the tape deck to the LINE OUT jacks (see pege 15).
AUX IN JACKS
This system can input analog sound signals through
these jacks.
Use a cable with RCA phono plugs to connect
audio equipment
(turntables,
LD players,
VCRs, TV, etc.).
Connect
the red plug to the R jack, and the white plug to the L
jack.
When
connecting
a turntable
Use an Aiwa turntable
equipped
with a built-in equalizer
amplifier.
CD DIGITAL OUT (OPTICAL) JACK
This system
can output
CD digital
sound
signals
through
this
jack.
Use an optical
cable to connect
digital
audio equipment
(digital
amplifier,
DAT deck, MD recorder,
etc.).
Remove
the dust cap @ from the CD DIGITAL OUT (OPTICAL)
jack.
Then,
connect
an optical
cable
plug to the CD DIGITAL
OUT (OPTICAL)
jack.
When the CD DIGITAL
OUT (OPTICAL)
jack
is not being
used
Attach the supplied
dust cap.
14
/3VGL/SH
Publicidad
