GE 20 Serie Manual Del Propietario E Instalación página 14

Installation
Instructions
Refrigerator
Models 20, 22, 25
I Questions?Call 800.GE.CARES (800.432.2737)or Visit
our Wehsite at:
www.GEAppliances.com
In Canada, call 1.800.361.3400 o r VisitourWebsit_ at:www.geappliances.ca
I
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - Save these
instructions for local inspector's use.
• IMPORTANT - Observe all
governing codes and ordinances.
• Note to Installer _ Be sureto leave
these
instructions with the Consumm:
• Note to Consumer _ Keep
these instructions
fbr future reference.
• Skill level - Installation of this applimlce requires
basic mechanical skills.
• Completion time - Refrigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(on some models)
If the refrigerator has an icemakm, it will have to be
connected to a cold v_-ater line. AGE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost fi'om your dealm,
by"visiting our Website at www.GEAppllances.eom
(in Canada, at www.geappliances.ea) or fi'om Parts
mad Accessories, 800.626.2002.
REFRIGERATOR LOCATION
• Do not install the refiigerator where the temperature
will go below 60°F (16°C) becmlse it will not run often
enough to maintain proper mmperatures.
• Install it on a floor strong enough to support it flfily
loaded.
CLEARANCES
:Mlow the following clearances for ease of installation,
proper air circulation and plumbing mad electrical
conllectiolls.
• Sides 1/8" (4 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
A door clearance of 3/4" (19 mm) is needed for a 90 °
door opening which provides better access to the food
storage area.
ROLLERS
The rogers have 3 purposes:
• Rollers
adjust so
the door closes easily when opened
about halfway.
Rollers
adjust so
the refrigerator is firmly positioned
on tim floor and does not wobble.
Rollers allow you to move the refiigerator away fi'om
the wall for cleaning.
To adjust the rollers, remove the base grille by pulling it
out at the bottom.
Turn the roller at_usting screv_ clockwise to raise the
refi'igerato_; counterclockwise to lower it. Use an
adjustable wrench (3/8" hex head bolt) or pliers.
To replace base grille, line up tim clips on back of grille
between the bar and the hottom of the cabineL Push
forward until grille snaps into place.
14