Kärcher OC 3 Plus Manual De Instrucciones página 11

2. Remove the valve opener using suit-
able pliers.
3. Remove the fine filter using suitable
pliers.
4. Clean the valve opener and the fine
filter under running water.
5. Insert the fine filter and the valve
opener into the device.
Error
The device does
not run
Cause
The charging state of the
battery is too low.
The motor is overloaded, the
motor circuit breaker has
tripped.
The ambient temperature is
outside the permissible
range (see chapter Techni-
cal data) and the motor cir-
cuit breaker has tripped.
ATTENTION
The pins on the fine filter and valve
opener must point upwards.
6. Place the water reservoir onto the
device.
Troubleshooting guide
DANGER
Contact with live parts
Injury due to electric shock
Before carrying out any work on the
device, switch it off and disconnect it
from the charger.
Have repair work and work on electri-
cal components carried out only by au-
thorized Customer Service personnel.
Malfunctions often have simple causes
that you can remedy yourself using the
following overview. When in doubt, or
in the case of malfunctions not men-
tioned here, please contact your autho-
rized Customer Service.
Rectification
1. Check the charging state of
the battery, charge the battery
if necessary.
1. Switch off the device.
2. Allow the device to cool down.
3. Switch on the device and put
it into operation.
1. Switch off the device.
2. Allow the device to cool down
or heat up.
3. Switch on the device and put
it into operation.
If the malfunction occurs sev-
eral times, contact the autho-
rized Customer Service.
English 11