Kärcher OC 3 Plus Manual De Instrucciones página 12

Error
Device does not
reach required
pressure
Strong pressure
fluctuations
The device is
leaking
Technical data
Electrical connection / battery
Nominal voltage of
battery
Nominal power of
device
Protection class
Protection class
Charger
Mains voltage for
charger
Output voltage
Output current
Phase
Frequency
Device performance data
Charging time for an
empty battery
Operating duration
with a fully charged
battery
12
Cause
Water shortage
The valve opener or fine fil-
ter are dirty.
The valve opener is installed
incorrectly.
The flat jet nozzle is dirty.
Water shortage
A slight leakage in the de-
vice is due to technical rea-
sons.
V 7,2
W 45
IPX4
III
V 100-130
V 9,5
A 0,6
~ 1
Hz 60
h 3
min 15
Rectification
1. Fill the water reservoir with
clear water.
1. Clean the valve opener and
the fine filter (see chapter
Cleaning the valve opener /
fine filter).
1. Insert the valve opener into
the device so that the pin
points upwards.
1. Clean the flat jet nozzle: Re-
move the dirt from the nozzle
bore with a needle and rinse
with water from the front.
1. Fill the water reservoir with
clear water.
1. In case of severe leakage,
contact an authorized Cus-
tomer Service center.
Operating pressure psi
Fresh water tank
volume
Suction height
(max.)
Ambient tempera-
ture
Dimensions and weights
Length
Width
Height
Weight (with acces-
sories)
Subject to technical changes without
notice.
English
72,52
(bar) (5)
gal 1,85 (7)
(l)
in 19,6
(mm) (500)
°F 32-104
(°C) (0-40)
in 9,3
(mm) (236)
in 11,15
(mm) (283)
in 14,22
(mm) (361)
lbs 20,5
(kg) (9,3)