Descargar Imprimir esta página

Kenmore 415.16106210 Manual De Uso Y Cuidado página 8

Ocultar thumbs Ver también para 415.16106210:

Publicidad

Idiomas disponibles

Idiomas disponibles

LP Tank
f
x, II
_I
• NEVER
store a spare
LP cylinder
under
or near the
appliance
or in an enclosed
area.
• Never fill a cyllnder beyond 80°/0 full.
• if the information
in the two points above is not
followed
exactly, a fire causing death or serious
injury may occur.
• An overfilled or improperly stored cylinder is a
hazard due to possible gas release from the safety
relief valve.
This could cause an intense fire with
risk of property damage, serious injury or death.
• if you see, smell or hear gas escaping, immediately
get away from the LP cylinder and appllance
and
call your fire department.
LP Tank
Removal,
Transport
And Storage
"Turn OFF all control knobs and LP cylinder
valve. Turn coupling
nut counterclockwise
by hand only - do not use tools to
disconnect.
Loosen cylinder
screw beneath
bottom
shelf or
disconnect
other retention
means, then lift PL cylinder
up and
and out of cart. Install safety cap onto LP cylinder
valve.
Always
use cap and strap supplied with valve.
Failure to use safety cap as directed
may result in serious
personal injury and/or
property
damage.
LP
Safety
Cap
Retainer Strap
" A disconnected
LP tank in storage or being transported
must
have a safety cap installed
(as shown). Do not store an LP
tank in enclosed
spaces such as a carport,
garage,
porch,
covered
patio or other building.
Never leave an LP tank
inside a vehicle
which may become
overheated
by the sun.
* Do not store an LP tank in an area where children
play.
8 ° 464424312
° 464424512
* The LP Tank used with your grill must meet the following
requirements:
= Use LP Tanks only with these required measurements:
]2"
(30.5cm)
(diameter)
x 18" (45.7 cm) (tall) with 20 lb. (9 kg.)
capacity
maximum.
" LP Tanks must be constructed
and marked
in accordance
with
specifications
for LP Tanks of the U.S. Department
of
Transportation
(DOT) or for Canada,
CAN/CSA-B339,
tanks,
spheres and tubes for transportation
of dangerous
goods.
Transport
Canada
(TC). See LP Tank collar
for marking.
" LP Tank valve must have:
* Type 1 outlet compatible
with
regulator
or grill.
* Safety relief valve.
* UL listed Overfill
Protection
Device (OPD). This OPD safety
OPD Hand Wheel
feature is identified
by a unique triangular
hand wheel. Use
only LP Tanks equipped
with this type of valve.
" LP Tank must be arranged
for vapor
withdrawal
and include
collar to protect
LP Tank valve. Always
keep LP Tanks in
upright
position
during
use, transit or storage.
LP Tank in upright
position
for vapor
withdrawal
LP
(Liquefied Petroleum Gas)
* LP gas is nontoxic,
odorless and colorless when produced.
For
Your Safety, LP gas has been given an odor (similar to rotten
cabbage)
so that it can be smelled.
" LP gas is highly flammable
and may ignite unexpectedly
when
mixed with air.
LP Tank
Filling
* Use only licensed and experienced
dealers.
" LP dealer
must purge new tank before filling.
" Dealer should NEVER fill LP Tank more than 80% of LP Tank
volume. Volume of propane
in tank will vary by temperature.
" A frosty regulator
indicates
gas overfill.
Immediately
close LP
Tank valve and call local
LP gas dealer
for assistance.
" Do not release liquid propane
(LP) gas into the atmosphere.
This is a hazardous
practice.
" To remove gas from LP Tank, contact
an LP dealer
or call a
local fire department
for assistance.
Check the telephone
directory
under "Gas Companies"
for nearest certified
LP
dealers.

Publicidad

loading

Este manual también es adecuado para:

640-04005537-8