Notice of use:
Never use the product in such dangerous zones as street,
road, slope or drain.
Never change the circuit and additional electric devices.
Never use remote control in rainy days or in the water,
never pour water or other liquid into the car.
Keep the product out of the fire, otherwise the car will be
damaged.
Only one child can use the product, and its weight cannot
exceed 25 KG.
Turn off the power when not in use and remove battery
connector when not using it for a long time.
As the product has battery charger, check whether wire plug
shell and other parts are damaged or not, and repair those
damaged parts.
The product must be assembled by the adult! Before
assembling, screws and pins are dangerous with sharp
points.
The following batteries or accumulators are
contained in this electronic device
Battery Type
6FM4.5
Information on the safe removal of the batteries or
accumulators
● Warning: Make sure the battery is completely drained.
● Open the seat, remove the screws on the iron sheet with a
screwdriver, remove the iron sheet and unplug the two wires from
the battery to remove the battery.
● Carefully remove the battery or accumulator.
● The battery or accumulator and the device can now be disposed
of separately.
12
Warnings
Chemical System
Lead(Pb)
Charging notice
Charge storage battery less than 18 hours, or the storage
battery will be damaged forever.
In charging, put DC Plug into the power socket, put charger
into power plug;never use the product during charging it.
The product can be used for one hour, and the charging
time is 8-10 hours, no more than 18 hours.
It is common for charger and storage battery to become
warm (temperature under 60
Never use the connector with the water, or short circuit will
happen.
Use the product's own charger, or it will cause charger and
storage battery to be damaged or short circuit.
Charge the product when not using it for a long time.
Charging steps are as follows
Step 1: Find the charge hole beneath the car seat
Step 2: Put the charger plug into the plug hole.
Step 3: Connect the charger to the power socket.
Relevant materials: PP plastics, k-carrageenan, generator,
battery and iron castings.
C) when charging.
O
EN
13