Descargar Imprimir esta página

Xylem FLOJET Triplex Diaphragm Manual De Instrucciones página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
TROUBLESHOOTING
WARNING: BEFORE SERVICING PUMP, TURN OFF PUMP AND DRAIN WATER FROM SYSTEM!!
Failure to Prime - Motor operates, but no pump discharge
• Restricted intake or discharge line
• Air leak in intake line
• Debris in pump
• Punctured pump diaphragm (pump leaks)
• Crack in pump housing
Motor Fails to Turn On
• Loose wiring connection
• Pump circuit has no power
• Blown fuse
• Pressure switch failure
• Defective motor
Pulsating Flow
• Restricted pump delivery. Check discharge lines, fit-
tings and valves for clogging or undersizing
SYSTEM CARE AND MAINTENANCE
Winterizing
Allowing water to freeze in the system may result in damage to the pump and plumbing system. Non-Toxic antifreeze for
potable water may be used with Flojet pumps. Follow manufacturers recommendations. Refer to coach or equipment man-
ufacturer's instructions for their specific winterizing and drainage procedures.
Do not use automotive antifreeze to winterize potable water systems. These solutions are highly toxic and may
cause serious injury or death if ingested.
1. Drain the water tank. Open tank drain valve and plumbing drain valves if applicable. You may use the pump to drain
the tank by opening all the faucets in the system. Allow the pump to operate until the tank is empty. Do not operate the
pump more than 15 minutes continuously.
2. Open all faucets and flush the toilet to purge all the water from the pump and the plumbing system. Run the pump
until no water is coming through the faucets. Turn power to the pump off. Be sure that all the water from the drain lines
are drained.
3. Remove quick connect inlet and outlet fittings from the pump and turn the pump on to pump out remaining water
from the pump head. Be sure to have a catch pan or a rag under the pump to prevent water from spilling on to the RV.
Turn the pump off once the plumbing is empty. Leave the fittings disconnected from the pump until the system is ready
to be used again. Make a note on your tank filler that the plumbing is not connected.
4. Be sure that all faucets are left open to protect against damage to the plumbing.
WARRANTY
XYLEM LIMITED WARRANTY WARRANTS THIS PRODUCT TO BE FREE OF DEFECTS
AND WORKMANSHIP FOR A PERIOD OF (2) YEARS. THE WARRANTY IS EXCLU-
SIVE AND IN LIEU OF ANY AND ALL OTHER EXPRESS OR IMPLIED WARRANTIES,
GUARANTEES, CONDITIONS OR TERMS OF WHATEVER NATURE RELATING TO
THE GOODS PROVIDED HEREUNDER, INCLUDING WITHOUT LIMITATION ANY
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, WHICH ARE HEREBY EXPRESSLY DISCLAIMED AND EXCLUDED. EX-
CEPT AS OTHERWISE PROVIDED BY LAW, BUYER'S EXCLUSIVE REMEDY AND
SELLER'S AGGREGATE LIABILITY FOR BREACH OF ANY OF THE FOREGOING
WARRANTIES ARE LIMITED TO REPAIRING OR REPLACING THE PRODUCT AND
SHALL IN ALL CASES BE LIMITED TO THE AMOUNT PAID BY THE BUYER HERE-
UNDER. IN NO EVENT IS SELLER LIABLE FOR ANY OTHER FORM OF DAMAGES,
WHETHER DIRECT, INDIRECT, LIQUIDATED, INCIDENTAL, CONSEQUENTIAL,
PUNITIVE, EXEMPLARY OR SPECIAL DAMAGES, INCLUDING BUT NOT LIMITED
TO LOSS OF PROFIT, LOSS OF ANTICIPATED SAVINGS OR REVENUE, LOSS OF
INCOME, LOSS OF BUSINESS, LOSS OF PRODUCTION, LOSS OF OPPORTUNITY
OR LOSS OF REPUTATION. THIS WARRANTY IS ONLY A REPRESENTATION OF THE
COMPLETE LIMITED WARRANTY. FOR A DETAILED EXPLANATION, PLEASE VISIT
US AT www.xylem.com/flojet, CALL OUR OFFICE NUMBER LISTED, OR WRITE A
LETTER TO YOUR REGIONAL OFFICE.
Pump Fails to Turn Off After All Fixtures Are Closed
• Empty water tank
• Insufficient voltage to pump (low battery)
• Punctured pump diaphragm (pump leaks)
• Discharge line leak
• Defective pressure switch
Low Flow and Pressure
• Air leak at pump intake
• Accumulation of debris inside pump and plumbing
• Worn pump bearing (excessive noise)
• Punctured pump diaphragm (pump leaks)
• Defective motor
RETURN PROCEDURE
Prior to returning any product to FLOJET, call customer
service for an authorization number. This number must
be written on the outside of the shipping package. Place
a note inside the package with an explanation regarding
the reason for return as well as the authorization number.
Include your name, address and phone number.
4

Publicidad

loading

Este manual también es adecuado para:

R3426-500