Publicidad
Idiomas disponibles
Idiomas disponibles
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following
measures:
Reorient or relocate the receiving antenna Increase the separation between
the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by
the part
responsible for compliance could void the user's authority to operate the
equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
26
Troubleshooting
Problem
Cause possible
Car does not
Possible Cause
move
Loose wire or
connectors
Dead battery
Undercharged
battery
Solution
Circuit breaker may "trip" and stop the
vehicle if it is overloaded or the driving
conditions too severe. The breaker will
automatically reset after approximately
10 seconds, and the vehicle will operate
normally. To avoid repeated automatic
shut downs, do not overload the vehicle
by exceeding the weight limited of
30kg(66 Ibs) Or by towing anything
behind the vehicle.
Do not drive up hills or run into fixed
objects, which can cause the wheels to
stop spinning while power is still being
supplied to the motors.
Check all wires and connectors. Make
sure that the motor harness connector is
plugged in tightly to the battery, and
that there are no loose wires around the
motor.
An old or improperly cared battery may
be dead. If you are unsure whether it is
dead or not, you can have it tested at
your Service Center.
A new battery should have been charged
for at least 12 hours before using the
vehicle for the first time. After that, it
must be recharge the battery for at least
8-10 hours after each use. Never charge
longer than 24 hours. Check all
connectors make sure the charger is
plugged into the wall. Make sure the
power flow to the outlet is on.
EN
27
Publicidad
