Costway TQ10072DE Manual De Instrucciones página 6

About Thermal Fuses
Your 12 volt battery is equipped with a built-in thermal fuse. The thermal
fuse is a self-resetting safety device which automatically trips and shuts
down operation of the vehicle if the vehicle is overloaded or the driving
conditions too severe. Once a fuse has tripped it will automatically reset
itself after approximately 10 seconds and allow the vehicle to resume normal
operations. To avoid repeated automatic shut downs, do not overload the
vehicle by exceeding the 66 lbs. (30 kg) maximum weight capacity or by
towing anything behind the vehicle.
Avoid severe driving conditions, such as driving up very steep slopes or
running into fixed objects, which can cause the wheels to stop spinning while
power is still being supplied to the motors.
Important Notes
● Your new battery must be charged for at least 12 hours before you use it
in your vehicle for the first time.
● You do not need to remove the battery from your vehicle to recharge it.
● The battery must be upright while charging.
● The charger is not a toy.
● Do not short circuit the battery.
● We recommend that you start charging your battery before beginning
assembly of your new vehicle.
● Before charging the battery, examine the battery case for cracks and other
damage which may cause sulfuric acid(electrolyte) to leak during the
charging process.
● If damage is detected, do not charge the battery or use it in your vehicle.
● Battery acid is very corrosive and can cause severe damage to surfaces it
contacts.
● Do not charge the battery on a surface which could be damaged by the
acid contained inside the battery. Take precautions to protect the surface on
which you charge your battery.
● If your battery is old and will not accept a charge, do not leave it in the
vehicle. Always remove a dead battery from the vehicle.
● Non-rechargeable batteries are not to be recharged.
● Rechargeable batteries are only to be charged under adult supervision.
10
● Only batteries of the same or equivalent type as recommended are to be
used.
● Batteries are to be inserted with the correct polarity.
● Exhausted batteries are to be removed from the toy.
● The supply terminals are not to be short-circuited.
EN
11