Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
ШСоппесііпо Procedures
Turn off your computer, Connect the signal connectors as shown below.
Turn the monitor on, then turn on the computer.
`
А, IBM PS/2 or PC/AT compatible models
Rear view
(D Connect the supplied signal cable to the monitor's port.
(2 Connect the other end of this cable to a power outlet.
B. Apple computer
Use a UNIMAC-82D MAC adapter
which is supplied standard.
Panasonic MAC adapter part No. is
UNIMAC-82D.
Caution:
To prevent the cable from coming loose,
the cable connectors must be securely
fastened with screws.
C. BNC connector signal computer
Horizontal sync
signal or composite
sync signal
Rear view
Green video
signal or sync
on green
(D Connect the BNC signal cable to the monitor's port.
(2) Connect the other end of this cable to a power outlet.
mConnection of AC Power Supply
If the AC power supply voltage is in the range 100 to 240V, either 50Hz or 60Hz frequency can be used.
There is no AC100V/240V selector switch.
Precaution:
* |n order to use the display unit safely, use a power cable that is properly grounded.
* AC plug cords for the following countries are supplied in the same package.
Canada....CSA
For use in other countries, make sure the AC cord meets the safety standards of each country.
Publicidad
