Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Federal Communications Commission Requirements
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
—
Reorient or relocate the receiving antenna.
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—
Consult the dealer or an experienced radio/TV technician for help.
—
Include ferrite core kit within shipping box; and provided instructions that if user is going to use
BNC connectors, they must attach ferrite core to their separately purchased BNC cable.
FCC Warning:
To assure continued compliance, the user must use grounded power supply cord; and the
provided shietded video interface cable with bonded ferrite cores. If BNC cable is going to be
used, the user must mount the provided ferrite core onto the BNC cable. Refer to page 22 for
ferrite core kit mounting instructions. Also, any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate
this device.
CE Conformit
This device complies with the requirements of the EEC directive 89/336/EEC as amended by 92/31/EEC
d E:
and 93/68/EEC Art. 5 with regard to "Electromagnetic compatibility". and 73/23/EEC as amended by
93/68/EEC Art. 13 with regard to "Safety".
TRANSIENT F/B
LINE HARMONICS
m
Y
NJ
#1 : Satisfies standards with no problems in performance and reliability.
#2 : Effects may yx ind temporarily on the screen but there will be no problem in reliability.
#3 : There is fear of the product breaking down.
#4 : На signal cable other than that specified is used, it will be the cause of electromagnetic wave
interruption of peripheral devices.
To assure continued CE compliance the user must use the provided 1.5 m shielded video
signal cable with bonded ferrite cores at both ends of the cable.
Handle correctly in accordance with the instruction manual.
EMI : Electromagnetic Interference
ESD : Electrostatic Discharge
RF : Radio Frequency
F/B : Fast Burst
—iv —
Publicidad
