Hohem iSteady MT2 Manual De Instrucciones página 20

How to set motor torque, fine tune motor angle, and pair with
GoPro camera?
1.Long press M button to enter OLED submenu "Motor Parameter Settings".
2.Single press button A/B, select "Motor Torque", "Motor Angle Fine-Tune", or "Pairing
with GoPro".
3.On"Motor Torque" screen: Push the joystick upwards/downwards to select motor
to adjust, leftwards/rightwards to adjust torque strength level (To perform auto self-
adaptation, select AUTO and single press M button to confirm. AUTO bars flashing
represents the stabilizer is performing self-adaptation; AUTO bars stops flashing, and
self-adaptation is completed.
4.On "Motor Angle Fine-Tune" screen: Push the joystick upwards/downwards to select
motor, leftwards/rightwards to fine tune motor angle.
5.On "Pairing with GoPro" screen: Ensure that camera enters pairing mode, push
upwards/downwards to select "PAIRING" or "UNPAIR", then single press M button to
confirm.
Buttons for A-B motion
For timelapse shooting, long-press button A/B to set the start/end
point to record the A-B motion timelapse.
Long press button A/B: A/B as start/end point (A short beep
signifies the successful setting）
Press button A/B once: Quickly return to the position A/B.
Press button A/B twice: Return to the position A / position B from
the current position at a constant speed. You will hear a short
beep as the movement begins or ends.
(Duration by default: 1 minute. You can customize duration in the
App.)
EN 15