Hohem iSteady MT2 Manual De Instrucciones página 24

③ Bluetooth: Connected
④ Battery Level:
Others
1. Standby: Stabilizer enters standby mode
2. Pan Axis Latch:
3. Error:
motor before using stabilizer, or the stabilizer is not leveled; or the
motor is subject to external interference.)
4. A-B Motion:
5.Auto Calibration:
6.Firmware Update:
7. Pair Remote Control(Sold Separately):
Pairing
8.Motor Torque Adjustment: Motor torque level of each axis;
Disconnected
Current Level
Pan axis is locked, unlock the Latch
Firmware error
Overloading (this error occurs when you didn't unlock the
Move to the position A from the current position at a
constant speed.
Move to the position B from the current position at a
constant speed.
Calibrating
Updating
Paired Successfully
AUTO represents the motor self-adaptation level (AUTO
bars flashing represents motor self-adaptation is being
performed; AUTO bars stop flashing represents the
completion of self-adaptation).
EN
Charging
Gyroscope error
19
Low Battery
Pairing Failed