Hohem iSteady MT2 Manual De Instrucciones página 22

07 How to Enable the AI Tracking
(AI vision sensor is sold separately)
1.Installing Magnetic Fill Light with
AI Vision Sensor (Sold separately)
Keep the "hohem" mark upward and
camera outward, then put the fill
light on the magnetic joint.
0.5~1.5m
4.Gesture "OK" to start the AI
tracking (Indicator light turns green).
It is completely normal for the magnetic alignment to become a
bit hot when fill light is in long-time use and hence.
DO NOT make a direct contact with the hot alignment, especially
the metallic part.
2. Enable the AI vision sensor:
Switch to "ON". (Indicator light
turns red with fill light flashing
twice.)
3. Gesture Control: Show gestures
to the AI vision sensor from
0.5~1.5m(1.64ft-4.92ft) away.
5.Gesture "PALM" to stop the AI
tracking (Indicator light turns red).
EN 17