Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACHING STAND TO SAW
Place saw (A) on stand assembly, while aligning the
screw holes in the saw stand with the threaded holes in
the saw base (Fig. 6).
Tighten hex cap screws to secure stand assembly to
saw.
NOTE: Do not over tighten.
Saw as assembled (Fig. 7).
HEIGHT ADJUSTMENT KNOB
INSTALLATION
Insert shoulder screw (f) into height adjustment
y
knob (g) as shown in Fig. 8.
Tighten shoulder screw with Phillips Screw driver
y
into Hand Wheel. Height adjustment knob should
rotate freely around shoulder screw when raising or
lowering the blade with the Height Adjustment Hand
Wheel.
ASSEMBLY
A
12
FIGURE 6
FIGURE 7
g
f
FIGURE 8
Publicidad
