Descargar Imprimir esta página

Delta ShopMaster S36-290 Manual De Instrucciones página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

While holding the blade guard assembly
position, as shown in Fig. 15, pull the blade guard
assembly pin all the way up into the rear slot on the
riving knife.
Rotate the blade guard assembly all the way down so
that the arms are parallel to the table (Fig. 15a). Then
lock the blade guard in place by depressing the lock tab
(Fig. 15b).
Do not hold lock tab in the lock position
while installing the blade guard.
After engaging lock tab to lock blade guard in place pull
up on arms to ensure guard is properly locked.
RIP FENCE
Position rip fence (B) over the table as shown in Fig. 16.
Lower the rear end of the rip fence (B) over the back of
the table; then lower the front end (with lock handle )
over the front of rail on the front of the saw. Engage lock
on the rip fence after placing fence in desired location
on the table (Fig. 16).
Do not use rip fence and miter gauge at
the same time without using a cut off block (gauge) as
described in the Cutting Aids and Accessories section
of this manual.
Check to ensure that the rip fence is secured to
the table prior to use when making a cut. If needed
adjustments to tighten or loosen rip fence can be made
by adjusting the lock nut on the rear side of the fence
(Fig. 17).
ASSEMBLY
(F)
in a vertical
15
F
SLOT
PIN
FIGURE 15
B
FIGURE 16
LOOSEN
FIGURE 17
a
ARMS
LOCK
TAB
b
TIGHTEN

Publicidad

loading