Publicidad
Idiomas disponibles
Idiomas disponibles
Before operation
Filling with compressed air
Important information about compressed air cartridges
The fastener driving tool may only be filled with the compressed air
cartridge KT-1000 included with delivery. An empty cartridge may
only be refilled by the manufacturer or using the manufacturer's PKT
series compressors. You can also buy a full compressed air cartridge
in exchange for an empty compressed air cartridge in specialist
stores.
The cartridge is sufficient for about 30 to 35 complete fillings of the
fastener driving tool.
Note as well:
• Use the compressed air cartridge KT-1000 for tools of the
manufacturer only if the operating manual of the relevant tool
explicitly specifies that cartridge type.
• Keep the valve of the compressed air cartridge and the screw
connection of the fastener driving tool clean and protect them
against damage. Remove dirt before screwing on the cartridge
and before placing the tool in operation. Heavy soiling may only
be removed by the manufacturer.
• Never use damaged compressed air cartridges.
• The labeling on the compressed air cartridge must not be made
illegible or removed.
32
WARNING
Danger of injury when filling improperly from
the compressed air cartridge.
The permitted pressure cannot be exceeded.
The connecting thread may also be damaged.
▶ Use only original compressed air cartridges
type KT-1000 from the manufacturer.
▶ Never try to fill an empty compressed air
cartridge using your own resources.
▶ Send empty cartridges back to the manufacturer
(for address see page 74).
Publicidad
