Prebena PKT-8-RHC40 Manual Del Usuario página 136

Operation
Setting down the fastener driving tool
The fastener driving tool has a specified resting position. The tool
has three padded areas on the right side for setting it down:
1 Padded area under the handle
2 Rear padded area
3 Tool tip padded area
▶ If work will be interrupted for a few minutes, set the fastener
driving tool down.
▶ Always set the fastener driving tool down so it is resting
on the three padded areas.
Using the locking plate
The fastener driving tool comes with 2 locking plates. Use them
with the corresponding nail length.
The locking plates prevent nails from jamming in the shot
channel.
54