12.2
Security instructions
Missing or non-readable security stickers have to be replaced immediately!
To avoid malfunction, machine defects and injuries, read the following security instructions!
The locally applicable laws and regulations may specify the minimum age of the operator and limit
the use of this machine!
Keep your work area dry and tidy! An untidy work area may cause accidents. Avoid slippery
floor.
Make sure the work area is lighted sufficiently
Do not use the machine outdoors!
Avoid abnormal working postures! Make sure you stand squarely and keep balance at all
times.
Keep away from the running saw band!
Always stay focused when working. Reduce distortion sources in your work-ing
environment. The operation of the machine when being tired, as well as under the influence
of alcohol, drugs or concentration influencing medicaments is forbidden.
The machine shall be operated by respectively trained persons only.
Do not allow other persons, particularly children, to touch the machine or the cable. Keep
them away from your work area.
Make your workshop childproof.
Wear suitable work clothes! Do not wear loose clothing or jewellery as they might get
caught in moving parts and cause severe accidents! Wear a hair net if you have long hair.
Use personal safety equipment: ear protectors, safety goggles, when working on dusty
jobs.
Never leave the machine running unattended! Before leaving the working area switch the
machine off and wait until the saw band stops.
Always disconnect the machine prior to any actions performed at the machine.
Avoid unintentional starting
Each time you work with an electrically operated sawing apparatus, caution is advised!
There is a risk of electric shock, fire, cutting injury;
Protect the machine from dampness (causing a short circuit)
Use power tools and machines never in the vicinity of flammable liquids and gases (danger
of explosion)
Check the cable regularly for damage
Protect the cable from heat, oil and sharp edges.
Avoid body contact with earthed
Use appropriate holding device when sawing logs
The upper blade guide to keep as close to the workpiece
Attach the fence to the lower half of the table for inclined table
Workpieces while working safely hold and guide
Remove the sawed-off or jammed workpieces only at standstill of the saw blade
Make sure that no excessive concentration of dust is produced. Use suitable dust extraction
equipment!
Remove before editing foreign matter (nails, screws) from the workpiece
For straight cuts against the rip fence push stick should be used
12.3
Remaining risk factors
It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
SAFETY
31
HBS 245HQ