14.2.5 Cutting speed
The cutting speed should be selected depending on the hardness of the
material to be machined.
hart: 400m/min
Open the lower cover.
Slacken driving belt by turning the knob clockwise.
Put driving belt on required pulley of the driving wheel (lower band saw wheel) and the
corresponding motor pulley.
If necessary, adjusting the motor position to adjust the belt tension.
Loosen the motor locking bolt (Fig.m; 1m) and turn the motor counter-clockwise to reduce
the driving belt tension, turn the motor clockwise to increase the driving belt tension.
Retighten the motor locking bolt.
Half-way between the pulleys the driving belt should flex approx 10mm.
Close the lower cover.
14.3
Operation
14.3.1 Switch Action (Fig.p)
To start/stop the machine push the main switch (2p)
To turn on/off the LED-work light push switch 1p
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T I C E
weich: 800m/min
OPERATION
36
HBS 245HQ