resideo WiFi L2 Instrucciones De Instalación página 5

Humidifier
Optional sail
1 2
switch or
current
sensing relay
3
Green
Orange
Red
White (not
Black
used)
The terminal block shown here is used on resideo HE150, HE250, and HE300 humidifiers.
1
The HE300 has a built-in transformer and doesn't require a transformer power in wires to
the humidifier.
2 See humidifier install guide for humidistat wiring and wiring to "equipment."
3 If an optional sail switch or current sensing relay is not used, the green wire from the
L2 goes directly to the humidifier.
L2
Fig. 8. L2 locks out advanced humidifier when water leak is detected.
L1
(hot)
R
24 VAC
L2
C
24 volt transformer
1 Resideo HE100, HE200, HE105, and HE205 have wires from the solenoid
as shown in this diagram.
The H6062 humidity control (pictured here) requires 24 Volts at R and C
2
from a transformer. Mechanical humidistats would not have R and C
terminals.
3
If an optional sail switch or current sensing relay is not used, the orange wire
from the L2 goes directly to the humidistat.
Fig. 9. L2 locks out basic by-pass humidifier when water leak is detected.
R
24 VAC
C
24 volt
transformer
24v constant
c
required
R
u
u
s
Outdoor sensor
s
Humidistat
2
Optional sail switch or
Current sensing relay
3
Orange
Red
Black
5
L2 WIFI WATER SENSOR AND SWITCH
L1
(hot)
1
L2
MCR39160
Humidifier
1
3
Green
White (not used)
L2
MCR39161
33-00631EFS—02