Publicidad
Idiomas disponibles
Idiomas disponibles
Device in normal operation with no leak alert
NOTE:
During test mode there is no WiFi communication to the L2 Water Leak and Freeze Detector.
WHEN A LEAK IS DETECTED
To Silence Alerts
Press the sensor's button or tap the mute button in the app to
mute the siren.
After you've addressed the cause of the alert, remove sensor
and cable sensor from water and wipe dry.
Solid LED:
white
Switch for
orange
(nc) and
Green
(com) wires closed.
Switch for white (no) and
Green
(com) wires open.
1s
M39153
Fig. 14.
Device in test mode
3x
Switch for
Green
(com) wires open.
Switch for white (no) and
Green
(com) wires closed.
Fig. 13.
TROUBLESHOOTING
Device not Powering On
Check wiring connections and ensure wires are connected to
the proper terminals.
Bluetooth Pairing Failed
If Bluetooth pairing fails at any stage, perform a factory rest.
Factory Reset
Press button for 1s to wake up device (solid blue LED). Then
press and hold button for 10s (solid orange LED). Two beeps
and solid red LED shows reset in progress. Once LED is off,
reset is complete.
7
L2 WIFI WATER SENSOR AND SWITCH
Blinking
LED
red
orange
(nc) and
MCR39163
1s
10s
M39273
Fig. 15.
33-00631EFS—02
Publicidad
