Shark HYDROVAC WD100 Serie Guia Del Usuario página 5

MAINTAINING YOUR 3-IN-1 CLEANER
MANUALLY CLEANING THE BRUSHROLL
You can clean the brushroll by hand as an alternative to the self-clean cycle, and to remove debris or hair
wrapped around the brushroll.
1. To access the brushroll, press the button on the top
of the nozzle and lift off the brushroll cover.
2
1
3. Reinsert the brushroll by lining up the grooves on the
end of the brushroll with the helix on the inner right side
of the nozzle, then press down on the left side of the
brushroll. When properly installed, the brushroll tab will
be flush with the left side of the nozzle
NOTE: Do not place brushroll in washing machine or dishwasher. Replace the brushroll after 6 months.
s h a r kc l e a n . c o m
1
2. Remove the brushroll by pulling up on the pull tab
on the left side of the nozzle. Wipe away any debris
stuck on the back wall
Wash thoroughly with warm water. Allow the
brushroll to air-dry completely in a well-ventilated
area for at least 24 hours.
3
1
1
2
4. To reinstall the brushroll cover, insert the tabs on the
cover into the slots on the nozzle. Press down on the
cover until it clicks into place.
MAINTAINING YOUR 3-IN-1 CLEANER
CLEANING THE DIRTY WATER TANK
2
1. To remove the dirty water tank, press the release
button and pull out the tank.
4
3. To dispose of solid debris, lift out the Solids
Separator. Grasp the recessed areas on the sides of
the separator and lift it out. Empty the solid debris
into the trash. If any liquid waste remains in the tank,
pour it down a drain. To clean, rinse the separator
and the tank with water.
NOTE: Replace the filter every 6 Months.
NOTE: Do not place dirty water tank in washing machine or dishwasher.
1
2. To dispose of liquid waste only, pour it out through
the Easy Pour spout on the back of the dirty water
tank.
3
Pull
from here
4. Clean the filter housing and the foam filter after
every use. Pull out the foam filter and hand-wash
with warm water and soap.
Allow the foam filter to air-dry completely in a well-
ventilated area for 24 hours before reinstalling back
into the unit.
s h a r kc l e a n . c o m
2
4