Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC OPERATIONS
SELECTION OF AUDIO/VIDEO
SOURCE
TAPE MONITOR/S.1CH
TAPE MONITOR
ENTER
Function indicators
FUNCTION
VIDEO/5.1CH/BAND
1 Select the program source.
Turn the FUNCTION selector or press the TAPE MONITOR
button. The selected function indicator lights in red.
To listen to or watch
| The indicator in red
Tape
TAPE MONITOR
Radio
TUNER
Record
| PHONO
Compact disc
CD
Television, etc.
Video
VIDEO 1/DVD/MD,
VIDEO 2/LD/TV, VIDEO 3
VIDEO 2/LD/TV
VIDEO 1/DVD/MD
1.
LD or Cable TV
MD or DVD
The function to be selected (except PHONO) depends on the
equipment connected to the input terminals on the rear panel
of the unit.
To select with the remote control
Press the TAPE MONITOR button or the FUNCTION button
repeatedly.
[NOTE
When using a turntable with a built-in equalizer amplifier, set
the switch of the equalizer amplifier to off. See the instructions
of the turntable for further information.
2 Start the selected program source.
3 Adjust the sound.
About the video source to the monitor or TV
Le
sue WOOFER @ }
{center
2
ae
iene
T-BasS:
a
:
Selected video source
V1: VIDEO 1, V2: VIDEO 2, V3: VIDEO 3
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
:
11 ENGLISH
To select the video source
:
1 Turn the FUNCTION to select PHONO, CD or AUX.
2 Press the ENTER button to display VIDEO 1.
3 Turn the MULTI JOG to select VIDEO 2 or VIDEO 3.
To change a displayed name for the VIDEO 1
and VIDEO 2
When the VIDEO 1 function is selected, VIDEO 1 is displayed
initially. It can be changed to DVD or MD.
Press the VIDEO/5.1CH/BAND button while pressing the ENTER
button, then release the ENTER button first.
To use the 5.1CH function, press the VIDEO/5.1CH/BAND button.
The function name will change to "5.1 ch IN" and the source
connected to the 5.1 INPUT terminals is selected.
To resume, press the button again so that the selected function
name is displayed.
The displayed name for the VIDEO 2 function can be changed
to VIDEO 2, LD or TV; while the VIDEO 2 function is selected,
press the VIDEO/5.1CH/BAND button while pressing the ENTER
button, then release the ENTER button first..
To adjust the sound level of the connected
source
The input sensitivity level of each function (except the TUNER
function) can be adjusted.
When the sound level of the connected source is higher or lower
than that of the TUNER, adjust it as follows.
1 Select the function to be adjusted.
Turn the FUNCTION and play the source.
2 Press the
A or \/ button repeatedly.
Le
sup WOOFER @ }
(O-centen
See
il
ac
&S
Cig
The level can be adjusted between -6dB (MIN) and +8dB
(MAX) in 2dB steps. Adjust the level so that the sound is output
at the same level as the TUNER.
[NOTE |
¢ The input sensitivity level of the TUNER function cannot be
adjusted.
* That of the TAPE MONITOR cannot be adjusted either.
Even if the TAPE
MONITOR
is selected
and the TAPE
MONITOR indicator turns red, pressing the "\ or \
button
will change the level of the function displayed on the window.
Publicidad
