Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
operate at low speed. Press the power button again; the appliance will switch off and the
brush will stop rotating.
Place the vacuum cleaner over the object to be cleaned, the UV light will start working.
-
Slowly move the device back and forth to clean. The recommended cleaning speed is 20
seconds per metre, three times back and forth.
When the vacuum cleaner starts running at full speed, the three indicator lights will turn
-
on, the lights will decrease until only one light is flashing, reminding the user to recharge
the appliance.
Note: to avoid accidental damage, place the UV-C lamp on the object to be irradiated and
avoid tilting it more than 10°. Exceeding this tilt degree will make the UV-C lamp automatically
switch off.
Recharge
The charging port of the device is located at the end of the handle. Turn off the vacuum
cleaner and plug in the adapter and insert the Type-C charging port on the device. When
all three charge indicators are illuminated, the battery is fully charged, the plug can be
disconnected from the mains adapter and the appliance can be used again.
Note: once charged, disconnect it from the mains, as keeping it plugged in once the battery
has been charged may affect the life of the battery.
4. CLEANING AND MAINTENANCE
Clean the high-efficiency filter regularly, as the absorbed cotton mites may not die and
continue to breed. To avoid secondary contamination, the high efficiency filter should be
cleaned after cleaning, or replaced with a new one.
Disassembly of the tank Fig. 2
1.
Rotate the dust tank, remove the dust container assembly.
2.
Remove the filter from the dirt tank.
3.
Remove the steel mesh from the frame.
Disassembly and cleaning of the filter Fig 3.
1.
Remove the filter from the dust tank in the direction shown in figure 3, then turn the dust
tank upside down and pour out the dust.
Wash the filter and tank components with water and allow to dry completely. It is
2.
very important that they are not reassembled until they have dried completely, which
can take up to 24 hours; otherwise, they may damage the internal components of the
vacuum cleaner.
44
Publicidad
