Publicidad
Idiomas disponibles
Idiomas disponibles
4. Connecting the equipment
ATTENTION: Bearing in mind operator's safe working conditions,
procedures detailed below should be carried out with the device
Powered-Off.
Check if there is no differences of potential voltage between the points
where the equipment shall will be connected to, nor between them and
the ground.
Connect the red security terminal (red cable) to the insulation tester (-V)
output terminal. Connect BNC terminal to the zero reference (+R) terminal
and the "alligators" terminals to the element to be measured as indicated
in the figure below.
The test leads in the picture are illustrative.
13
Publicidad
