•
Before to use this instrument the User guide and Safety warnings must be read
and understood.
•
Safety procedures and rules for working near high voltage energized systems
must be observed during the use of this equipment. The generated voltages may
be dangerous.
•
Do not connect or disconnect the test leads during the measurement.
Be careful not to make short-circuit between the high voltage terminals and the
•
"+R" or "Guard" terminals while a measurement is running, because it could be
dangerous for the operator.
Be sure that there are not any voltage difference between the points to which the
•
insulation tester will be connected to, neither between them and ground.
•
The panel, terminals and connectors of the equipment must stay dry and clean.
This equipment should be used only by a trained and competent
person, strictly applying suitable safety rules.
Used symbols
Caution, risk of electric shock.
Caution, refer to User guide.
Equipment complies with current EU Directives.
Safety warnings
4