Publicidad
Idiomas disponibles
Idiomas disponibles
Hazards may arise from improper use of the DRESTER Compact DC12. Hazards may also arise from improper choice/handling of
drums or solvent. In order to maintain the high safety standard of the unit, it is important that these instructions are followed.
-
Do not operate the unit until you have read and fully understood this entire User's Manual.
-
The unit should be isntalled as described in the instructions.
-
The unit should be used as described in the instructions.
-
The unit should be maintained as described in the instructions.
-
Only original spare parts may be used.
-
This User's Manual must be available and in legible condition in close proximity to the unit. Every user shall know where
to find the User's Manual.
-
Operating instructions should be formulated on the basis of this Users Manual, and translated into the language spoken by
the employees.
-
Do not modify or in any way alter the unit.
-
Do not operate the unit unless it is properly vented. Do not operate the unit if the extraction of vapors is insufficient.
-
Avoid contact with liquid and vapor. Refer to the solvents' MSDS (Material Safety Data Sheet).
-
Wear chemical goggles or similar, to protect your eyes. Wear chemical-resistant gloves to prevent skin-contact. Wear
chemical-resistant clothing to protect against spills or splash.
-
Personnel suffering from respiratory problems or allergies to solvents used, must not operate the machine.
-
Clean up spills immediately. Solvent vapours are heavier than air and can spread a long way. They may also collect in pits
or other low areas.
-
Do not smoke, eat or drink while close to the unit.
-
The unit is equipped with a safety valve that will interrupt the automatic wash cycle if the lid is opened before the wash
cycle is completed.
-
A fire extinguisher must always be kept nearby when working with flammable solvents. Do not use water.
-
Spray guns or any other paint equipment items cleaned in the unit must be suitable for cleaning in a Zone 1 area (ref.
Category 2 according to EN 13463-1/2001). If unsure, please contact the spray gun manufacturer.
-
The unit must be properly grounded using the attached grounding cable. If plastic drums are used, the openings should be
wiped off with a damp cloth, to avoid static electricity, before inserting or removing any hoses or other equipment.
Manufacturer
Type of machine:
Permitted solvents:
Max solvent volume of machine:
(Check for local regulations concerning max allowed volume for keeping solvent in the unit)
Maximum drum size:
Compressed air needed:
Extraction capacity:
Pump capacity:
Solvent pressure
Weight
Overall dimensions:
Extractor diameter:
Sound pressure level:
INSTR: 17625
SAFETY INFORMATION
TECHNICAL DATA
HEDSON TECHNOLOGIES AB
Hammarvägen 4
SE-232 37 Arlöv
Sweden
Tel.: +46-40- 53 42 00
DRESTER Compact DC12
See section "Permitted Solvents"
15 + 15 litres
30 litres
7-12 bar (110-180 psi), 300 litres/min (11 cfm)
3
360 m
/hour (225 cfm) (with a 5 m extension)
3
330 m
/hour (206 cfm) (with a 15 m extension)
10 l/min
2 bar (30 psi)
30 kg (66 lb)
Height: 1340 mm (53") width (without drums): 570 mm (22,5")
Depth (lid closed): 440 mm (17,5")
Depth (lid opened): 590 mm (23")
80 mm (3 3/16")
<70 dB(A)
REV: ECO-10003 2014-11-06 / TB
GODK:
SID: Sida 7 / 37
Publicidad
